2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Toe-In Adjustment (Rear)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Dodge Intrepid, 2004 Chrysler Concorde, 2004 Chrysler 300M, 2003 Dodge Intrepid, and 2003 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: On vehicles with adjustable rear toe settings, rear adjustments should be set first, then adjust front settings.

Loosen lateral link jam nuts. Rotate adjustment link as required to set toe-in to specification. Ensure lateral link does not exceed maximum lengths. See LATERAL LINK MAXIMUM DIMENSIONSΒ  table. Tighten jam nuts to specification. See TORQUE SPECIFICATIONSΒ  .

LATERAL LINK MAXIMUM DIMENSIONS

Application Dimension "A" - In. (mm) Dimension "B" - In. (mm) Dimension "C" - In. (mm)
Concorde, Intrepid & 300M (1) 14.96 (380) 3.5 (90)
(1) Forward lateral link is not adjustable.
Fig 1: Identifying Lateral Link Maximum Dimensions
G99B03377Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.