2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Section 56 (Electrical Component Locator): Grounds

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
GROUNDS LOCATION

Component Location
G100 (2.7L) At right rear side of engine. See Figure.
G100 (3.5L) At rear of engine. See Figure.
G101 (2.7L) At left rear side of engine. See Figure.
G101 (3.5L) At left rear side of engine. See Figure.
G102 At left rear of engine compartment. See Figure.
G103 At left rear of engine compartment. See Figure.
G104 Behind left headlamp.
G105 Near right horn. See Figure.
G106 Near right horn. See Figure.
G107 On left side of transmission bellhousing, near starter.
G108 Near battery. See Figure.
G200 At lower center of dash. See Figure.
G201 At lower center of dash. See Figure.
G300 Under driver's seat. See Figure.
G301 Under passenger's seat. See Figure.
G310 Deck lid ground. See Figure.
G311 At right "C" pillar.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.