Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Sentry Key Immobilizer Module Bulb Check

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, 2003 Chrysler 300M, and 2002 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.

Note operation of sun sensor/Vehicle Theft Security System (VTSS) Light Emitting Diode (LED) located on top of instrument panel during check. Turn ignition switch to ON position. Sentry Key Immobilizer Module (SKIM) should send message to BCM to turn LED on for about 3 seconds. After 3-second bulb check, SKIM sends message to turn LED off for about one second. If LED comes on and stays on after one-second off period, there is a malfunction in the Sentry Key Immobilizer System (SKIS). If LED flashes and a single chime tone is heard, an invalid key was used to attempt vehicle start-up.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.