2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Component Locations

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, 2003 Chrysler 300M, and 2002 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS

Component Location
Body Control Module On Back Of Junction Block
Data Link Connector Under Left Side Of Instrument Panel, Above Brake Pedal
Deck Lid Release Switch Left Side Of Instrument Panel, Above Parking Brake Release
Door Lock Switch On Appropriate Door Panel
Ignition Switch In Right Side Of Steering Column
Junction Block Behind Left End Of Instrument Panel
Power Distribution Center Left Side Of Engine Compartment
Powertrain Control Module Left Side Of Engine Compartment
Remote Keyless Entry Module Between BCM & Junction Block, On Back Of Junction Block
Sentry Key Immobilizer Module In Steering Column, By Ignition Switch
Sun Sensor/Vehicle Theft Security System LED Top Center Of Instrument Panel
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.