2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Tire Pressure Verification Test

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a scan tool or the EVIC RESET button, set the EVIC to Diagnostics mode (blank screen).
  2. Set to EVIC as follows, press and hold the EVIC RESET button for 5 seconds (EVIC will beep). Set the EVIC to display BLOCK COUNTERS.
  3. A vehicle graphic will display showing counters at wheel locations.
  4. Drive vehicle at 25 MPH (40 KM/H) for at least 2 minutes.
  5. Observe that the counters increment at least 3 sensor/transmitter receptions for each wheel. Can the EVIC be trained and do the counters show Sensor/Transmitter receptions? If yes, repair is complete. If no, see DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.