WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.

Possible Causes:

Bus Messages Missing
Failed Self Test
EVIC Self Test

Testing

NOTE: This test is written specifically for use with Chrysler's Diagnostic Readout Box (DRBIII(R)) scan tool.

Turn ignition off. Connect scan tool to Data Link Connector (DLC). Using scan tool, select BODY, EVIC, SYSTEM TEST, then SELF-TEST. Press any scan tool key. If scan tool displays FAILED SELF TEST, replace Electronic Vehicle Information Center (EVIC). If scan tool displays BUS MESSAGES MISSING, perform BUS MESSAGES MISSING test. If scan tool displays TEST SUCCESSFUL, fault may be intermittent. Check related wiring and connectors for poor connections or damage to wiring harness. See WIRING DIAGRAMS . Repair any problems found as necessary. If no problems are found, check if any Technical Service Bulletins (TSBs) apply to vehicle. If no TSBs apply, test is complete.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

EVIC Self-Test

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?