WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.

Monitored & Set Condition

When Monitored: With the ignition on.
Set Condition: The BCM interfaces with the ATC head over the PCI Bus. If any ATC switch is held in the closed position for longer than 5-10 minutes, a switch failed code will be set.

Possible Causes:

ATC Head Switch Stuck
ATC Head - Erase DTC - Reset

Testing

Turn ignition on. With the scan tool select Automatic Temp Control, Input/Output and observe the switch state. If any of the switch states read CLOSED, replace the automatic temperature control head. See AUTOMATIC A/C-HEATER SYSTEMS - CONCORDE, INTREPID & 300M article in HVAC. If any of the switch states do not read CLOSED, use the scan tool to erase the trouble code and reset the module using scan tool.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

ATC Recirculation Switch Failure

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?