Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Chime Sounds With Driver Door Open Key Removed
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes:
- Key-In SW Status
- Key-In Ignition Shorted
- Key-In Ignition SW Sense Short To Ground
- Body Control Module
Testing
- Ensure all exterior lights are off. With the scan tool select: BODY COMPUTER, Input Output. Read the Key-In Ignition SW. Remove the key from the ignition switch. If the scan tool shows Key-In IGN OPEN, replace the BCM. See BODY CONTROL MODULEΒ under REMOVAL & INSTALLATION. If the scan tool does not show Key-In IGN OPEN, go to next step.
- Disconnect the ignition switch connector. If the chime turned off, check the ignition lock cylinder for damage. If OK, replace the ignition switch. See IGNITION SWITCHΒ under REMOVAL & INSTALLATION. If not OK, go to next step.
- Turn ignition off. Disconnect the BCM C2 connector. Using a DVOM, measure the resistance of the key-in ignition switch sense circuit to ground at the ignition switch connector. If the resistance is below 100 ohms, repair the key-in ignition switch sense wire for a short to ground. If the resistance is 100 ohms or more, go to next step.
- If there are no possible causes remaining, replace the BCM. See BODY CONTROL MODULEΒ under REMOVAL & INSTALLATION.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
