Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Rear Mount: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, and 2004 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

Position isolator onto crossmember.
Install bolts attaching isolator to crossmember and tighten to 33 N.m (250 in. lbs.) (Figure).
Lower transaxle onto isolator.
Install isolator nuts and tighten to 61 N.m (45 ft. lbs.) (Figure).
Lower vehicle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.