Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Spark Plug Tube: Installation
WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Apply Mopar® Stud and Bearing Mount to a new tube approximately 1 mm (0.039 in.) from the end of tube, in a 3 mm (0.118 in.) wide area.
- Install sealer end of tube into the cylinder head. Then carefully install the tube using a hardwood block and mallet. Install the tube until it is seated into the bottom of the bore.
- For spark plug tube seal replacement, (Refer to REMOVALÂ ).
- Install cylinder head cover(s). (Refer to INSTALLATIONÂ )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.