2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Oil Pump: Installation

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prime oil pump before installation by filling rotor cavity with engine oil.
  2. Install oil pump and gasket carefully over the crankshaft. Position pump onto block and tighten bolts to 28 N.m (250 in. lbs.)
  3. Install new O-ring on oil pickup tube.
  4. Install oil pickup tube.
  5. Install oil pan. (Refer to INSTALLATION ).
  6. Install crankshaft sprocket. (Refer to INSTALLATION ).
  7. Install timing belt. (Refer to INSTALLATION ).
  8. Install the timing belt covers. (Refer to INSTALLATION ).
  9. Install the crankshaft vibration damper. (Refer to INSTALLATION ).
  10. Install the accessory drive belts. (Refer to ACCESSORY DRIVE ).
  11. Install the radiator fan. (Refer to RADIATOR FAN ).
  12. Fill the cooling system. (Refer to STANDARD PROCEDURE ).
  13. Fill engine crankcase with proper oil to the correct level.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.