Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Cluster Bezel: Installation
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Connect headlamp switch connector. Place the cluster bezel into position and snap it into place firmly.
- Install the two screws over upper cluster bezel in instrument panel brow area and all remaining attaching screws.
- Install the items covering the bezel mounting screws.
- Install the one screw (Concorde/300M) to cluster bezel
To service any instrument cluster component, the instrument cluster must be removed from the instrument panel. Use the following procedure:
- Tilt the steering column down into the highest position.
- Install the steering column shroud cover.
- Install the instrument panel left end cap.
- Connect the negative battery cable remote terminal to the remote battery post (Figure ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.