2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Junction Block: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install Junction Block/BCM to vehicle.
  2. Connect BCM wire connectors and RKE antenna connector.
  3. Install Junction Block/BCM.
  4. Install wire harness connectors to Junction Block/BCM.
  5. Install four mounting screws.
  6. Install under column ducts.
  7. Install left knee blocker.
  8. Connect cable to hood release, decklid release switch wiring, and install two screws to lower instrument panel.
  9. Install left end cap.
  10. Connect the negative battery cable remote terminal to the remote battery post.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.