Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0206 Injector #6 Control Circuit: Description
Fuel injector operation is monitored with battery voltage is more than 10.4 volts, ASD relay energized, injector pulse width less than 10 milliseconds, and engine speed less than 3000 RPM. DTC will set in Powertrain Control Module (PCM) memory .64-10.00 seconds after PCM does not sense any inductive kick 18 milliseconds after injector is turned off, and no other injectors are turned on. Possible causes for DTC to set are: defective injector, defective PCM, defective connectors or defective wiring.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
