2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Avenger & Sebring Coupe (V6)

  1. Remove rear seat cushion. Remove protector for access to fuel pump electrical connector. Fuel pump electrical connector is located on top of fuel tank. Disconnect fuel pump electrical connector from wiring harness.
  2. Start engine and allow engine to idle until engine stalls. Turn ignition switch to OFF position. Reinstall fuel pump electrical connector, protector and rear seat cushion. Fuel system components may now be serviced. Cover fuel lines with shop towel before disconnecting, as some residual fuel pressure may exist.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.