Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Self-Diagnostic System: Precautions
Before proceeding with diagnosis, observe following precautions:
- Ensure battery is fully charged.
- Probe PCM connector from pin side. DO NOT backprobe PCM connector or probe wires through insulation.
- DO NOT cause short circuits when performing electrical tests. This will set additional DTCs, making diagnosis of original problem more difficult.
- DO NOT use a test light in place of a voltmeter.
- Always begin repair with lowest DTC number (MIL) or first DTC displayed (scan tool).
- Always perform verification test after repairs are made.
- Always disconnect scan tool after use.
- Always disconnect scan tool before charging battery.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
