Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Seat System: Description
Power seat system consists of 4 single-armature, permanent-magnet, reversible motors coupled through cables to 2 worm gear box assemblies, a control switch assembly and a wiring harness. The circuit is protected by a 40-amp fuse in Power Distribution Center (PDC) and a 20-amp circuit breaker in the fuse box. The power seats can be adjusted in 8 directions: up/down, forward/backward, tilt forward/backward, and recline up/down.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.