2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Using DVOM

Remove power seat switch from mounting position. See POWER SEAT SWITCHΒ  under REMOVAL & INSTALLATION. Using a DVOM, check continuity between specified power seat switch terminals (component side). See POWER SEAT SWITCH CONTINUITY TESTΒ  table. See Fig 1 . If continuity does not exist between specified terminals as specified, replace power seat switch.

POWER SEAT SWITCH CONTINUITY TEST

Switch Position Left Seat Switch Terminals No. Right Seat Switch Terminals No.
Off
5 & 2 5 & 2
5 & 3 5 & 3
5 & 4 5 & 4
5 & 6 5 & 6
5 & 7 5 & 7
5 & 8 5 & 8
5 & 9 5 & 9
5 & 10 5 & 10
Front Riser Up
5 & 6 5 & 9
1 & 9 1 & 6
Front Riser Down
1 & 6 1 & 9
5 & 9 5 & 6
Center Switch Forward
1 & 10 1 & 10
3 & 5 3 & 5
Center Switch Rearward
1 & 3 1 & 3
5 & 10 5 & 10
Rear Riser Up
1 & 8 1 & 7
5 & 7 5 & 8
Rear Riser Down
1 & 7 1 & 8
5 & 8 5 & 7
Recliner Up
1 & 4 1 & 4
2 & 5 2 & 5
Recliner Down
1 & 2 1 & 2
4 & 5 4 & 5
Fig 1: Identifying Power Seat Switch Terminals
G99I02060Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.