Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Memory Position No. 2 Stuck
- Turn ignition off. Disconnect memory set switch harness connector. Connect scan tool to Data Link Connector (DLC). Using scan tool, check memory position 2 status. If OPEN is not displayed, go to next step. If OPEN is displayed, replace memory set switch.
- Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM) harness connector C1. Measure resistance between ground and terminal No. 4 (Pink/White wire) at memory set switch harness connector. See Figure . If resistance is greater than 1000 ohms, replace MHSMM. If resistance is 1000 ohms or less, repair short to ground in Pink/White wire between memory set switch and MHSMM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.