Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Courtesy Lights Inoperative From Headlight Switch
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). Using scan tool, check courtesy light status. Turn courtesy lights on using headlight switch. If ON is not displayed, go to next step. If ON is displayed, replace BCM.
- Check White wire between terminal No. 19 at Body Control Module (BCM) harness connector C2 and terminal No. 6 at headlight switch harness connector for opens and shorts. If problem exists, repair wiring as necessary. If problem does not exist, replace headlight switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.