Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Chime Sounds With Driver's Door Open (Ignition Key Removed)
- Ensure all exterior lights are off. Remove key from ignition switch. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, monitor key-in ignition status. If CLOSED is displayed, go to next step. If CLOSED is not displayed, replace Body Control Module (BCM).
- Turn ignition off. Disconnect ignition switch harness connector. Turn ignition on. Using scan tool, monitor key-in ignition status. If CLOSED is displayed, go to next step. If CLOSED is not displayed, replace ignition switch.
- Turn ignition off. Disconnect BCM harness connector C2. Measure resistance between ground and terminal No. 24 (Light Blue wire) at BCM harness connector C2. See Figure . If resistance is greater than 100 ohms, replace BCM. If resistance is 100 ohms or less, repair short to ground in Light Blue wire between ignition switch and BCM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.