Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
OTIS Switch Test
- Turn ignition off and leave key in ignition. Open driver's door. If chime sounds, go to next step. If chime does not sound, repair chime system as necessary. Perform appropriate test under CHIME SYSTEMS .
- Turn ignition on. Close driver's door. Press each button on OTIS and listen for audible beep at Body Control Module (BCM). If beep was heard each time a button is pressed, problem is intermittent. If beep was not heard each time a button was pressed, replace OTIS module.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.