Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Memory Switch Inoperative
NOTE:
Ensure seat frame is connected to ground if seat is unbolted from vehicle.
- Turn ignition off. Disconnect memory set switch harness connector. Measure resistance between ground and terminal No. 3 (Black wire) at memory set switch harness connector. See Figure . If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Black wire between memory set switch and ground.
- Turn ignition on. Measure voltage at terminals No. 4 (Pink/White wire), No. 5 (Pink/Black wire) and No. 6 (Pink/Red wire) at memory set switch harness connector. If any voltage is .5 volt or less, go to next step. If all voltages are greater than .5 volt, replace memory set switch.
- Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM) harness connector C1. Measure resistance in appropriate wire(s) between memory set switch harness connector and MHSMM harness connector C1. See MEMORY SET SWITCH CIRCUITS table. See Figure and Figure . If resistances are 5 ohms or less, replace MHSMM. If any resistance is greater than 5 ohms, repair open in appropriate wire between memory set switch and MHSMM.
MEMORY SET SWITCH CIRCUITS
| Set Switch Terminal No. | MHSMM Terminal No. | Wire Color |
|---|---|---|
| 4 | 25 | Pink/White |
| 5 | 13 | Pink/Black |
| 6 | 12 | Pink/Red |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.