Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Removal & Installation
- Powertrain Control Module (PCM) is located at driver's side front corner of engine compartment, between power distribution center and Transmission Control Module (TCM). See Figure .
- Disconnect negative battery cable at remote battery terminal on passenger's side strut tower. Remove speed control servo with bracket and lay aside.
- Remove filler neck from windshield washer fluid bottle. Remove TCM for access to PCM. Remove PCM retaining bolt and pull PCM outward. Disconnect harness connectors from PCM. Remove PCM. To install, reverse removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.