Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid (CANADA) V6-3.2LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Transmitter: Adjustments
PROGRAMMING REMOTE KEYLESS ENTRY TRANSMITTER(S)
The Remote Keyless Entry (RKE) Transmitter(s) can be programmed with the use of the DRB III scan tool, or by the customer.
PROGRAMMING TRANSMITTER WITH THE DRB III SCAN TOOL
For procedures on programming the transmitter(s) with the DRB III scan tool, refer to the proper Body Diagnostic Procedures.
PROGRAMMING BY CUSTOMER
For a customer to be able to program RKE transmitters themselves, at least one RKE transmitter must be programmed already. This procedure is to add additional transmitters. If all transmitters are lost, the DRB III scan tool must be used to program the new transmitter(s).
Transmitter programming by the customer is done by continually pressing the unlock button, on a programmed fob, for a minimum of 4 seconds to a maximum of 10 seconds with the ignition switch ON. Within the 4-10 second range, the panic button is depressed. Both buttons are then released.
The BCM will chime. Them press any button on each fob to be programmed. The BCM will chime as each fob is learned. To exit program mode, turn off ignition or wait 32 seconds. The BCM will chime again.
The Remote Keyless Entry (RKE) Transmitter(s) can be programmed with the use of the DRB III scan tool, or by the customer.
PROGRAMMING TRANSMITTER WITH THE DRB III SCAN TOOL
For procedures on programming the transmitter(s) with the DRB III scan tool, refer to the proper Body Diagnostic Procedures.
PROGRAMMING BY CUSTOMER
For a customer to be able to program RKE transmitters themselves, at least one RKE transmitter must be programmed already. This procedure is to add additional transmitters. If all transmitters are lost, the DRB III scan tool must be used to program the new transmitter(s).
Transmitter programming by the customer is done by continually pressing the unlock button, on a programmed fob, for a minimum of 4 seconds to a maximum of 10 seconds with the ignition switch ON. Within the 4-10 second range, the panic button is depressed. Both buttons are then released.
The BCM will chime. Them press any button on each fob to be programmed. The BCM will chime as each fob is learned. To exit program mode, turn off ignition or wait 32 seconds. The BCM will chime again.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.