Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2000CIRRUS L4-2.4L VIN XREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIR
2000 Chrysler Cirrus L4-2.4L VIN X
Control Assembly: Service and Repair
2000 Chrysler Cirrus L4-2.4L VIN XSECTION Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative remote cable.
2. Remove center bezel by pulling rearward to disengage four clips and remove attaching screws from cubby bin.
3. Remove the HVAC control attaching screws. Pull the control out to disconnect two electrical connectors and two control cables. Remove HVAC control.
INSTALLATION
For installation, reverse the above procedures. The forward edge of bin must engage the forward console.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.