Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Controls - Tests W/Codes - Convertible: Introduction: Notes
Perform all steps in appropriate BASIC DIAGNOSTICS PROCEDURES article. If no fault is found while performing basic diagnostic procedures, proceed with self-diagnostics. If no Diagnostic Trouble Codes (DTCs) are present after entering self-diagnostics, perform TEST NTC-1: NO TROUBLE CODE TEST MENU under SELF-DIAGNOSTIC TESTS for engine diagnosis. If after performing TEST NTC-1, problem is not identified and repaired, proceed to TROUBLE SHOOTING - NO CODES - GASOLINE article for diagnosis by symptom.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.