Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Power Windows: Troubleshooting
- Check circuit breaker No. 1 (20-amp) in junction block. Junction block is located under left side of instrument panel.
- Check fuse "J" (40-amp) in Power Distribution Center (PDC). PDC is located in left side of engine compartment, next to battery.
- Check for good ground at instrument panel, at left side cowl.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.