1999 Chrysler LHSFACTORY OEM SERVICE PROCEDURE

Body Verification Test

  1. Reconnect all previously disconnected components and connectors. If BCM was replaced, turn ignition on for at least 15 seconds. Program all RKE transmitters, recalibrate HVAC doors and program other options as necessary.
  2. If vehicle is equipped with VTSS, select MISCELLANEOUS and ENABLE VTSS. If battery was disconnected, start engine and recalibrate HVAC doors using scan tool.
  3. Ensure ignition is on. Erase all DTCs using scan tool. Turn ignition off and wait 5 seconds. Turn ignition on and fully operate system that was malfunctioning.
  4. If system is not operating properly, go to SYMPTOM ID TEST 1A . Using scan tool, read Body DTCs. If any DTCs are present, go to SYMPTOM ID TEST 1B . If no DTCs are present, system is operating correctly and customer's complaint cannot be duplicated, repair is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.