Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1998 Chrysler CirrusFACTORY OEM SERVICE PROCEDURE

Battery Specifications

Fig 1: Battery Location

Courtesy of CHRYSLER CORP.

Vehicle is factory equipped with a maintenance free battery. The top of the battery is permanently sealed, and water never has to be added, and periodic maintenance is not required either. But, periodically check the battery terminals and battery hold-down bracket for corrosion. Replace with a battery of the same group number as shown on original battery's label.

NOTE: Battery is stored in a compartment behind the left front fender and is accessible by turning the steering wheel fully to the left and removing the inner fender shield (removal of tire and wheel is not required). Remote battery terminals are located in the engine compartment for jump starting.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.