Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chrysler CirrusFACTORY OEM SERVICE PROCEDURE
V6 Throttle Position Sensor
NOTE:
Throttle Position (TP) sensor is nonadjustable. Use following procedure to check TP sensor calibration. For complete testing of TP sensor and wiring circuit, see appropriate TESTS W/CODES
article.
- Remove components for access to electrical connector at TP sensor mounted on throttle body. With electrical connector installed on TP sensor, turn ignition on with engine off. DO NOT start engine.
- Using Digital Volt-Ohmmeter (DVOM), check voltage at center terminal on electrical connector for TP sensor with throttle valve closed (idle position). Voltage should be greater than .60 volt.
- Slowly open throttle to full throttle and note voltage reading. Voltage should smoothly increase to less than 4.5 volts. Replace TP sensor if voltage is not within specification.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
