Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chrysler CirrusFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| Air Bag Control Module | Under floor console, behind transmission selector. |
| Body Control Module | On junction block, under left side of dash. |
| Controller Anti-Lock Brake | At right front of engine compartment. |
| Daytime Running Lamp (DRL) Module | Behind dash, on back of multi- function module. |
| Fuel Pump Module | In center rear of trunk. |
| Mode Door Actuator | At left end of HVAC housing. |
| Powertrain Control Module | Left fender side shield, attached to power distribution center. See Figure . |
| Speed Proportional Steering Module | On left side of steering gear. See Figure . |
| Sun Roof Control Module | At rear of sun roof. |
| Transmission Control Module | Left fender side shield, attached to power distribution center. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
