1997 Chrysler LHSFACTORY OEM SERVICE PROCEDURE

DRB Scan Tool

WARNING: This page is about a different car, the 1996 Eagle Vision, 1996 Dodge Intrepid, 1996 Chrysler New Yorker, 1996 Chrysler LHS, and 1996 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DRB scan tool instructions to read and clear fault messages, and when performing other scan tool function.

DRB scan tool is grounded through DLC connector. Only one volt/ohmmeter test lead is required when instructed by testing to measure voltage or resistance on specified circuit. DRB scan tool volt/ohmmeter should only be used when body control computer tests require the use of this option.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.