Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS
| Component | Component Location |
|---|---|
| Blend Door Actuator | On left side of HVAC. |
| Blower Motor Resistor Block | Behind right side of dash, on bottom of A/C-heater case. |
| Data Link Connector | On left side of steering column. |
| Electronic EGR Transducer (EET) | Near EGR valve. |
| Ignition Coil Pack (3.3L) | On side of left cylinder head, at rear. See Figure . |
| Ignition Coil Pack (3.5L) | On side of right cylinder head, at rear. See Figure . |
| Mode Door Actuator | On left side of HVAC housing. |
| Power Amplifier | On left side of trunk. |
| Power Antenna | Right rear quarterpanel. |
| Recirculation Door Actuator | On right side of HVAC. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.