1997 Chrysler LHSFACTORY OEM SERVICE PROCEDURE

Traction Control Function (TRAC CONT) Light

The Green TRAC CONT light is located on message center in instrument panel. When ignition is first turned on, TRAC CONT light will come on for 2 seconds as a bulb check and then go off. TRAC CONT light is used to inform driver that LTCS has entered traction control mode. TRAC CONT light is controlled by CAB.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.