Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Test 84B - Incorrect Ambient Temperature Reading
NOTE:
Perform TEST 84A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAMS
. Drive vehicle to update OTIS and perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
- Disconnect Body Control Module (BCM) Bone and Gray connectors. BCM is located behind right kick panel. Using scan tester in ohmmeter mode, measure resistance at terminal No. 15 (Gray/Tan wire) on BCM Bone connector. If resistance is less than 500 k/ohms, repair Gray/Tan wire for partial short to ground. If resistance is 500 k/ohms or greater, go to next step.
- Using scan tester in ohmmeter mode, measure resistance at terminal No. 10 (Violet/Light Green wire) on BCM Gray connector. If resistance is less than 500 k/ohms, repair Violet/Light Green wire for partial short to ground. If resistance is 500 k/ohms or greater, go to next step.
- Using external ohmmeter, measure resistance between terminal No. 15 (Gray/Tan wire) on BCM Bone connector and terminal No. 10 (Violet/Light Green wire) on BCM Gray connector. If resistance is less than 500 k/ohms, repair Violet/Light Green wire for short to Gray/Tan wire. If resistance is 500 k/ohms or greater, replace BCM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
