1996 Chrysler Concorde LXiFACTORY OEM SERVICE PROCEDURE

Connector Identification

NOTE: Circuit location may vary on some connectors.
CONNECTOR IDENTIFICATION DIRECTORY

Connector Figure
A/C Compressor Relay Fig 1
Auto Shutdown (ASD) Relay Fig 2
Brakelight Switch Fig 3
Camshaft Position (CMP) Sensor Fig 4
Clockspring 2-Pin Speed Control Connector Fig 5
Clockspring 4-Pin Speed Control Connector Fig 6
Crankshaft Position (CKP) Sensor Fig 7
Engine Coolant Temperature (ECT) Sensor Fig 8
Evaporative Solenoid Fig 9
Exhaust Gas Recirculation (EGR) Solenoid Fig 10
Fuel Pump Fig 11
Fuel Pump Relay Fig 12
Generator Field Fig 13
High Speed Radiator Fan Relay Fig 14
Idle Air Control (IAC) Motor Fig 15
Ignition Coil Fig 16
Injector Fig 17
Intake Air Temperature (IAT) Fig 18
Left Downstream Oxygen Sensor (O2S - Harness Side) Fig 19
Left Upstream Oxygen Sensor (O2S - Harness Side) Fig 20
Low Speed Radiator Fan Relay Fig 21
Manifold Absolute Pressure (MAP) Fig 22
Powertrain Control Module (PCM) Fig 23
Right Downstream Oxygen Sensor (O2S - Harness Side) Fig 24
Right Upstream Oxygen Sensor (O2S - Harness Side) Fig 25
Speed Control Servo Fig 26
Starter Relay Fig 27
Throttle Position (TP) Sensor Fig 28
Torque Converter Clutch (TCC) Solenoid Fig 29
Transmission Range Sensor Fig 30
16-Pin Data Link Connector (DLC) Fig 31
Fig 1: A/C Compressor Relay Connector
G96F01568Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.