1995 Chrysler Sebring LXiFACTORY OEM SERVICE PROCEDURE

Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Preferred Range
Camber (1)
Front 0 - 0.5 To 0.5
Rear (4) - 1.3 - 1.5 To - 0.9
Caster (1)(2) 4.3 2.8 To 5.8
Toe-In (1)
Front 0 - 0.25 To 0.25
Rear 0.24 0 To 0.48
Toe-In (3)
Front 0 - 0.12 To 0.12 (- 3 To 3)
Rear .12 (3) 0 To 0.24 (0 To 6)
(1) Measurement is in degrees.
(2) Left to right caster differential must not exceed 1 1/2Β° degrees.
(3) Measurement is in inches (mm).
(4) Left-to-right camber differential must not exceed 1/2Β° degree.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.