1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE

CLOCKSPRING Centering

NOTE: If clockspring is not positioned properly in relation to steering column and front wheels, clockspring failure will result. Following procedure must be used to center clockspring.
  1. If steering wheel has not already been removed, disable the air bag system. Refer to SERVICE PRECAUTIONS . Also, refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Position front wheels straight-ahead. Center steering wheel. Remove air bag module, vibration damper, and steering wheel. See STEERING WHEEL & HORN PAD  under REMOVAL & INSTALLATION.
  3. Press auto-locking tabs in center of clockspring. See Fig 1. Rotate clockspring rotor clockwise to end of its travel. Rotate clockspring rotor counterclockwise 2 1/2 turns from end of its travel. When clockspring is positioned correctly, horn wire will be at top of clock-spring and air bag module wire at bottom. Locking tabs will be horizontal.
  4. Install steering wheel, vibration damper, and air bag module. See STEERING WHEEL & HORN PAD  under REMOVAL & INSTALLATION. DO NOT  connect negative battery cable yet. See SYSTEM OPERATION CHECK  for additional procedures.
Fig 1: Identifying Clockspring Components
G91H07774Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.