1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure: Introduction

WARNING: This page is about a different car, the 1995 Plymouth Neon, 1995 Eagle Talon, 1995 Dodge Neon, 1995 Dodge Avenger, and 1995 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding with diagnosis, certain precautions must be followed. See PRETEST INSPECTIONΒ  under SELF-DIAGNOSTIC SYSTEM.

Diagnostic test procedures are designed to detect system faults as quickly as possible. Body Diagnostic Trouble Codes (DTCs) are accessed through Data Link Connector (DLC). Chrysler's Diagnostic Readout Box (DRB) scan tool or generic scan tool, is used to access information from DLC.

A 1995 diagnostic program cartridge, scan tool, body diagnostics cable, hand-held oil pressure gauge, jumper wires, and digital volt-ohmmeter will be needed for testing. Proceed to TEST 1AΒ  . Ensure self-diagnostic tests apply to vehicle being tested. See BODY CONTROL COMPUTER TESTS DIRECTORYΒ  table. When system problem is identified according to customer's complaint, perform diagnostic test(s) indicated.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.