Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE
Test VER-1 - Verification Procedure
- Reconnect all components that were previously disconnected. Ensure ignition is off and scan tool is connected. Turn ignition on, engine off. If scan tool screen is blank, go to TEST 2A. If scan tool screen is not blank, go to next step.
- Using scan tool, perform BUS test. If there is a bus failure message on scan tool, go to TEST 1A. If there is no bus failure message on scan tool, select module in question. If scan tool shows NO RESPONSE, go to TEST 1A.
- If scan tool does not show NO RESPONSE, inspect vehicle for original complaint. If original complaint is present, go to TEST 1A. If original complaint is not present, repair is complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.