1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE

Test VER-1 - Verification Procedure

  1. Reconnect all previously disconnected components and connectors. Ensure all repairs have been made. Using scan tool, erase Diagnostic Trouble Codes (DTCs). Turn ignition off. Wait 5 seconds. Turn ignition on. Go to next step.
  2. Fully operate system that was malfunctioning by turning switch on, opening door, etc. If system does not operate properly, go to TEST 1A. If system operates properly, go to next step.
  3. Using scan tool, read body control module DTCs. If any DTCs return, go to TEST 1B. If no DTCs return, repair is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.