Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE
Ignition Switch Test
- If both starter solenoid and starter relay are okay, problem exists with ignition switch or wiring from ignition switch to starter relay. Remove steering column covers to locate ignition switch Black 7-pin connector. Check for loose or corroded connections and repair as necessary.
- Using test light, backprobe Red wire of ignition switch connector to ensure battery voltage to switch. If test light does not illuminate, check Red wire for open or short circuit.
- Using test light, backprobe Yellow wire of ignition switch connector for starter relay circuit check. Turn ignition switch to START position. If test light does not illuminate, replace ignition switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.