1995 Chrysler LeBaronFACTORY OEM SERVICE PROCEDURE

Shift Quality Quick-Learn Procedure

  1. This procedure quickly optimizes shift quality. Procedure must be performed after disconnecting battery or loss of voltage supply to Transaxle Control Module (TCM), replacing TCM, transaxle internal components, solenoid assembly or torque converter.
  2. Chrysler's Diagnostic Readout Box (DRB) scan tool with proper cartridge must be used to perform shift quality quick-learn procedure. The following conditions must be met when performing shift quality quick-learn procedure: oil temperature must be greater than 60°F (16°C), brakes must be applied when indicated, engine speed greater than 500 RPM, throttle angle less than 3 degrees, gearshift must be moved only when indicated, gearshift must remain in overdrive as indicated until DRB indicates procedure is completed.
  3. If unused replacement TCM is installed on vehicle with engine at normal operating temperature, shift quality quick-learn procedure will cause TCM to indicate a cold oil temperature. Oil temperature must be monitored with DRB.
  4. If oil temperature is less than 60°F (16°C), allow engine to idle until oil temperature is greater than 60°F (16°C). If oil temperature is greater than 200°F (94°C), allow transaxle to cool until oil temperature is less than 200°F (94°C).
  5. Connect DRB to data link connector, located near brake pedal at bottom of instrument panel. Using proper cartridge and DRB manufacture's instructions, move through program to enter 41TE/AE menu. Start vehicle. Select ADJUSTMENTS function.
  6. Apply brakes. Select QUICK-LEARN function. Place gearshift in Neutral and then "OD" (overdrive) when indicated. Wait until TEST COMPLETE is indicated on DRB. Place gearshift in Park. Release brakes. Remove DRB.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.