Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Steering Column: Overhaul
- Remove steering column from vehicle. Remove steering column shaft coupling. Bend tabs on jacket bushing, at base of steering column, and slide bracket off bushing. Tap jacket bushing off of steering column.
- If replacement jacket bushing comes assembled with bracket, remove bracket before installing jacket bushing. Align tab on jacket bushing with slot in steering column jacket. Press jacket bushing onto steering column jacket using Adapter (MB990800).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.