1995 Chrysler LHSFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Bearing Retainer Mounting Bolt 124 (168)
Brake Hose-To-Caliper Banjo Bolt 35 (48)
Brake Tubes-To-All Fittings 13 (17)
Caliper Bleed Screw 11 (15)
Caliper Guide Pin Bolt 30 (41)
Caliper-To-Knuckle Bolt 15 (20)
Master Cylinder-To-Booster Nut 21 (28)
Parking Brake Assembly Mounting Screws 21 (28)
Power Booster Assembly-To-Dash Nut 21 (28)
Wheel Lug Nut (1) 81-100 (110-135)
INCH Lbs. (N.m)Β 
CAB-To-HCU Screw 106 (12)
Brake Hose Intermediate Bracket Bolt 106 (12)
Brakelight Switch Bracket Screw 71 (8)
Proportioning Valve 106 (12)
Wheel Cylinder Bleed Screw 89 (10)
Wheel Cylinder Mounting Bolt 71 (8)
Wheel Speed Sensor Screw 60 (7)
(1) Tighten nuts in crisscross sequence to half torque, then tighten to full torque.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.