Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Transmitter Programming
- Remove upper center bezel from instrument panel and locate traction control Black connector. See Fig 1 . Disconnect connector. Turn ignition switch to ON position.
- Ground connector terminal No. 4. See Fig 2 . Door locks will lock and unlock to indicate that system is ready to receive codes. Trunk solenoid will not cycle at this time. Press any button on transmitter to set code. Locks will cycle to confirm programming.
- If a second transmitter is used, it must be set at this time. Press any button on second transmitter and wait for locks to cycle. Disconnect program line from ground. This returns system to normal operation. Replace upper center bezel to instrument panel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.