Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Speed Control Menu
- To perform cruise control system tests using scan tool, scan tool must be in SPEED CONTROL MENU. At SPEED CONTROL MENU, trouble codes and scan tool test functions can be accessed. To reach SPEED CONTROL MENU, turn ignition off. Connect scan tool to data link connector. Connector is located under center of dash, right of steering column. Turn ignition switch to RUN position.NOTE: DO NOT touch scan tool keypad during scan tool power-up sequence or an error message will result.
- All scan tool character positions will glow and copyright information will appear on screen for a few seconds. If scan tool screen is blank or any error messages appear, proceed to the TESTS W/CODES - BODY CONTROL COMPUTER article in the ENGINE PERFORMANCE section.
- After a few seconds scan tool menu will appear. At scan tool menu, press "4" (SELECT SYSTEM) key. Press ENTER key. At SELECT SYSTEM menu, press "1" (ENGINE) key. Press ENTER key. Scan tool menu will appear indicating engine year, size, type of transmission and PCM part number.
- After a few seconds AIR COND menu will appear. Press "1" (WITH A/C) or press "2" (WITHOUT A/C). Scan tool display will change to ENGINE SYSTEMS menu. At ENGINE SYSTEMS menu, press "3" (SPEED CONTROL) key. Press ENTER key.
- Display will change to SPEED CONTROL. At SPEED CONTROL MENU, specific test functions programmed into scan tool can be performed. Following scan tool modes can be accessed: SYSTEM TESTS, READ TROUBLE CODES, STATE DISPLAY, ACTUATOR TESTS and ADJUSTMENTS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
