1994 Chrysler LHSFACTORY OEM SERVICE PROCEDURE

DRB-II Key Functions

WARNING: This page is about a different car, the 1993 Dodge Dynasty, 1993 Chrysler New Yorker Fifth Avenue, 1993 Chrysler New Yorker, and 1993 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.

  • YES Or Down Arrow & NO Or Up Arrow

    Keys will move lines on screen up or down, allowing technician to choose an item or scroll through all selections available.
  • F1 & F2 Keys

    Keys are used to scroll through sensor displays.
  • ATM Key

    Key will return technician to previous screen.
  • ENTER Key

    Allows technician to select a test or display. The flashing arrow must be on the display user wishes to select. Pressing the ENTER key in the sensor state will cause display to change from a 3-line display to a 1-line display.
  • F3 Key

    Key is used to display a help screen. This key may be used at any time.
  • Number Keys

    Keys are used for choosing a display or test by pressing the number for the test or display.
  • READ/HOLD Key

    Key is used to freeze any sensor display.
  • MODE & ATM Keys

    Pressing MODE and ATM keys at the same time will cause DRB-II to reset to copyright screen.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.