Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
SELECT SYSTEM Mode
- This mode enables technician to select system to be diagnosed. At DRB menu, press "4" (SELECT SYSTEM) key. Press ENTER key. DRB will display SELECT SYSTEM menu.
- At SELECT SYSTEM menu, press "3" (BODY) key. Press ENTER key. DRB should display BUS TEST IN PROGRESS, BUS OPERATIONAL. After a moment, SELECT MODULE menu should appear.
- If a bus failure message appears during BUS TEST IN PROGRESS, proceed to VEHICLE COMMUNICATIONS. Always start at TEST 1A.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
